diskpana.blogg.se

Intel 82578dc gigabit network connection disable reenable
Intel 82578dc gigabit network connection disable reenable












intel 82578dc gigabit network connection disable reenable intel 82578dc gigabit network connection disable reenable

It deals with a different problem, but, explains how to install new versions. Thought this might be done to a driver problem. Is there something else I should be looking at? I suppose I would have expected to have an entry for eth0 in there but maybe not. etc/network/interfaces looks like this in either case: Resources: memory:de200000-de21ffff memory:de224000-de224fff ioport:2020(size=32)Īfter rebooting, when the network is running, the same command outputs this:Ĭapabilities: pm msi bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiationĬonfiguration: autonegotiation=on broadcast=yes driver=e1000e driverversion=1.0.2-k4 duplex=full firmware=0.10-5 ip=192.168.0.108 latency=0 link=yes multicast=yes port=twisted pair speed=100MB/s Product: 82578DC Gigabit Network Connection If I run lshw -C network when the networking isn't running, I get this: I shut down, left the computer off for a few seconds, then booted it. Immediately after removing them, I rebooted and the network was up. I removed the cisco vpn software and the problems persist. The only other "weird" thing is that I installed a CISCO vpn client 4.8.02 (0030), which required some patch to make it work, I followed the information here: Nvidia GTX 460 with the restricted drivers installed using the packager Intel motherboard with integrated sound & network Does anyone have any idea what is going on or how I should approach troubleshooting this issue? The network card is an integrated 10/100/1000. This happens every time I cold boot: no network, reboot, network works. When I then use the menu to reboot the computer, when it comes back, the network card is shown and works perfectly. When I click it, it shows no "eth0" or similar, it just has the "VPN" menu item. The network icon in the top right shows two computers with a small X between them. Everything seemed to work for a few days, but now when I start the computer from "off" it starts with no network. I installed Ubuntu 10.10 on a fresh hard drive (well, ssd). I recently built a new computer (specs follow).














Intel 82578dc gigabit network connection disable reenable